Rod Desyne 100-69-666-D Installationsanleitung

Stöbern Sie online oder laden Sie Installationsanleitung nach Nein Rod Desyne 100-69-666-D herunter. Rod Desyne 100-69-666-D Installation Guide Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 1
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
NOTE: Finial shown is for illustration purpose only.
It may not represent the style of nial purchased.
INSTALLATION INSTRUCTIONS FOR ROD SET
Lock rods into position by tightening leveling screw by hand
until finger tight. this will prevent the rod from moving.
6
Extend rod to desired width. Lift rod with drapery and drop into brackets.
Adjust draperies to desired position.
5
Place brackets against wall at desired locations.
Mark screw holes with pencil. Be sure marks are
level across opening.
1
If screws are going directly into wood trim or
wall stubs, drill a 1/8” pilot hole at pencil marks.
If screwing into drywall, follow drywall anchor
instruction in the bottom of the page.
2
Assemble rod and sheer drapery
treatment onto rod.
3
MOUNTING FINIALS
There are two diameters of
white inserts included. For a
three piece rod, there is only
one diameter of white insert.
Turn the end of the finial
screw (clockwise) into flatted
end of the white insert until
base of the finial is sung to
insert face. (see PIC 1, 2)
Push each insert into the
(corresponding size) end of
the pole with the fins of the
insert going into the pole.
PIC 1
screw finials onto rod, rotate finial on rod
for proper alignment if required.
Turn the end of the finial screw (clockwise)
into flatted end of the white insert
PIC 2
insert until base of the finial
is sung to insert face
FLATTED END
CORRESPONDING SIZE
clockwise
biggest line
4
If screws are going directly into wood trim or wall studs - drill 1/8” (3mm) holes and install screws through bracket.
If screws are going into hollow wall - drill 3/16” (5mm) holes and push or lightly hammer plastic anchors into holes.
Then install screws through brackets. Do not tighten screws too much - just snug is best.
DRYWALL ANCHOR
INSTALLATION
O
Seitenansicht 0
1

Inhaltsverzeichnis

Seite 1

NOTE: Finial shown is for illustration purpose only.It may not represent the style of nial purchased.INSTALLATION INSTRUCTIONS FOR ROD SETLock rods i

Kommentare zu diesen Handbüchern

Keine Kommentare